FREE SHIPPING on orders over $59
Cart 0

My Lampe Berger Fragrance Lamp Will Not Stay Lit, Please Help

Are you having a problem keeping your Lampe Berger fragrance lamp lit?  If so, the information below will probably help you.

First off, make sure that you are using only original Lampe Berger fragrance oils in your fragrance lamp.  Provided that is the case, the reason your Lampe Berger burner will not stay lit is probably because the wick has soaked up too much fragrance oil and has become overly saturated.  This usually occurs because of one of the following reasons:

  1. Your lamp is filled too high with fragrance oil - Lampe Berger recommends that you fill your fragrance lamp up to 2/3 the way full and no more.  But, in our experience filling your fragrance lamp 1/2 full with fragrance oil is better, especially if you are having this problem.
  2. Your wick needs replacement - You should replace your Lampe Berger Wick / Burner every year or 200 uses, whatever comes first. Also, do not use the cheaper knock off brand catalytic burners in your Lampe Berger because they do not work very well.

If you are using a newer wick / burner with original Lampe Berger fragrance oils, following these steps below will probably help get your burner working properly again.  First, remove your wick / burner from the lamp and place it somewhere safe away from children and pets to dry out for about 24 hours.  Then, make sure your fragrance lamp is no more than 1/2 full with the Lampe Berger oil.  Finally, replace your dried out wick and follow the instructions for first time use of your Lampe Berger Lamp.

In our experience this will solve your problem of the Lampe Berger burner not staying lit the majority of the time.  Give it a try, it can't hurt, won't cost you anything and will probably greatly improve your Lampe Berger usage experience. 

Lampe Berger Fragrance Oil Lamps

Older Post Newer Post

  • Fragrance Oils Direct on

    Dave, be sure to not fill your lamp more than half full as it can make the wick over saturated and not stay lit.

  • Fragrance Oils Direct on

    Liz Smith,
    It sounds like your wick is working perfectly. It is not supposed to emit smoke or a flame. You should feel a little bit of heat and smell the fragrance.

  • Liz Smith on

    I have a beautiful Lampe and also cannot get it to stay lit. New dry wick and ceramic head still no help. I can smell the fragrance but no smoke.

  • Triv on

    I’ve done all the troubleshooting and wick still does not stay lit. It is dark in color but not wet. How long does the wick last. I’ve only used it 10 or 15 times. Could it have been a defective wick?

  • Dave on

    Put new wick in it lights just find but does not continue to emit the fragrance. It does not remain hot which is why it stops emitting. Any ideas of what could cause this?

Leave a comment

Please note, comments must be approved before they are published